TNY289PG

The TNY289PG is an energy-efficient offline Switcher with line compensated overload power. TinySwitch-4 combines a high-voltage power MOSFET switch with a power supply controller in one device. Unlike conventional PWM controllers, it uses a simple ON/OFF control to regulate the output voltage. The controller consists of an oscillator and enables circuit (sense and logic), current limit state machine, 5.85V regulator, BYPASS/MULTIFUNCTION pin undervoltage, overvoltage circuit and current limit selection circuitry, over-temperature protection, current limit circuit, leading edge blanking and a 725V power MOSFET. TinySwitch-4 incorporates additional circuitry for line undervoltage sense, auto-restart, adaptive switching cycle on-time extension and frequency jitter. The drain pin is the power MOSFET drain connection. It provides internal operating current for both start-up and steady-state operation.

• Line compensated overload power - No additional components
• Dramatically reduces max overload variation over universal input voltage range
• Simple ON/OFF control, no loop compensation needed
• Selectable current limit through BP/M capacitor value
• Higher current limit extends peak power/in open frame, maximum continuous power
• Allows optimum TinySwitch-4 choice by swapping devices with no other circuit redesign
• Maximizes MOSFET and magnetic utilization
• ON-time extension - Extends low-line regulation range/hold-up time to reduce input bulk capacitance
• Self-biased - No bias winding or bias components
• Frequency jittering reduces EMI filter
• Pin-out simplifies heat sinking to the PCB
• SOURCE pins are electrically quiet for low EMI
• Accurate hysteretic thermal shutdown protection with automatic recovery eliminates need for reset
• Output overvoltage shutdown with optional Zener
• Fast AC reset with optional UV external resistor
• Very low component count enhances reliability and enables single-sided printed circuit board layout
• High bandwidth provides fast turn-ON with no overshoot and excellent transient load response
• Extended creepage between DRAIN and all other pins improves field reliability
• Easily meets all global energy efficiency regulations
• ON/OFF control provides constant efficiency down to very light loads
• No-load <lt/>30mW with bias winding, <lt/>150mW at 265VAC without bias winding
• Auto-restart delivers <lt/>3% of maximum power in short-circuit and open loop fault conditions
• ±5% Turn-ON UV threshold - Line voltage sense with single external resistor
• 725V Rated MOSFET - Increases BV de-rating margin

Applications

Power Management, Consumer Electronics, Industrial, Metering, Audio

Warnings

Market demand for this product has caused an extension in leadtimes. Delivery dates may fluctuate. Product exempt from discounts.